Rapid Rollerdoor PLUS with guide rails, Height 3.10 m

Optimum access to buildings

Rapid Rollerdoors PLUS are of the same construction as Electric Rollerdoors PLUS. Rapid Rollerdoors PLUS can be operated with little effort using a chain drive (similar to the agridoor). The additional centre tube increases the stability of the door even with higher wind loads. This ensures a longer lifespan and operational safety. By including the optional side guide rails, the door is additionally sealed and can still be opened easily even in light wind conditions. The door is sealed at the bottom with a bottom flap, compensating for any ground unevenness.

1. Steel tubing
All Rapid Rollerdoors and Electric Rollerdoors are delivered with 100 mm diameter tube

2. Establishing the dimensions
The width and height of the ordered Rapid Rollerdoor dictate the actual dimensions of the mesh. The tubes are approximately 100 mm longer than the rollerdoor width (50 mm on each side). The maximum mounting width measures the nominal width -3 cm (e.g. RRP3031FS = max. mounting width 2.97 m). On Rapid Rollerdoors the drive can be mounted on the right or the left. Please specify desired drive side when ordering. Clearance height reduces by 100 mm.

3. Fitting adjustment
Minimum width 2.40 m. The height can be varied by the positioning of the tube (superfluous net remains wrapped on the tube).

4. Bottom flap
Rapid Rollerdoors are delivered with a bottom flap of 14 cm as standard. Bottom flaps of 34 cm and 51 cm can be supplied at a surcharge.

5. Guide rails
All Rollerdoors can be equipped with side guide rails. This ensures a tight closure of the door at the sides and allows the user to operate the door even at high wind speeds.

6. Colour
Special mesh available in green, blue, beige, grey, brown and black at no extra charge

The rollerdoor width has to be cut to size on site, for height adjustment any remainder can remain wound onto the upper tube.